Glowforge Starter Kit

Perfect starter kit for the new Glowforge Owner!

**Includes **
4x – Riser Blocks
1x – Exhaust Extension
5x – “L” Shaped Low Profile Honeycomb Pin
5x – “T” Shaped Low Profile Honeycomb Pin

– Exhaust Extension –
Fitting a vent hose to the back of your Glowforge can be a challenge. This extension will make it much easier. Attach the tube to the extension first, and then fit to the Glowforge. The fitting is tight and may need to be tapped on for a full fit.

– Riser Blocks –
Riser blocks allow you to remove your crumb tray and still get your material within focus area of your laser head. Can be used for all laser cutters.
Blocks consist of 5 steps in 1/4″ increments.

Holes in the bottom of the riser can hold a 5mmx3mm rare earth magnets if you like to add them.
Magnets Sold separately (will not be installed, attach with glue) – 5mm x 3mm
https://www.etsy.com/listing/1037544062/add-on-magnet-set-for-acrylic-tumbler

If using for a Glowforge you must remove the provided crumb tray before using these.

– Material Pins –
These Material Pins were created specifically for a laser cutter, and have been tested in a Glowforge. This listing includes Honeycomb pins to hold your material to your Glowforge crumb tray. They are lower profile when used then the normal pins.

**Dimensions**
.834″x.912″

** Notes / Disclaimer **
All items are 3D printed out of PLA+

Due to the nature of 3D printed items, there may be slight imperfections that will not affect the laser cutting